Wire Decking

Wire Decking

Welded Wire Decking makes inventory easier to see and handle, reduces fire hazard, maximizes, and simplifies product handling.  Inventory stays clean, neat and organized.  Here’s Strength with economy, easy to install and no maintenance.

Request for Quote

Features

  • Starting at $15.00 each
  • Powder Coated Finish
  • Galvanize Finish Available
  • Varieties of sizes are available
  • Makes bulk storage fire code compatible
  • Wire decks permit light, air and sprinkler penetration
  • Easy install by simply dropping them into place over beams
any qestion

Specifications & Video

Standard

Flared

Inside Waterfall

Flush

Inverted Channel

Upturned Waterfall


Design with standard support channels to accomodate standard 1 1/2″ or 1 5/8″ step beams.

Waterfall design with flared support channels to accomodate box and structural type beams.

Wire is hidden inside the step leaves beam faces unobstructed.

Flat mesh ends even with the top of beam with no bend.

Decking with the support channels inverted for food storage and other clean applications.

Decking with the rear waterfall turned up to serve as a backstop to prevent cartons from being pushed off the back of the back.

How To Order Wire Decking

Determine the beam length measurement that the decks are going to be installed on by measuring the inside edge of the beam connector where it would sit flush with the side of the upright frame. Note that you want to use the measurement that is similar to your desired pallet racking bay widths.

Example: A 96″ beam will have a measurement from the inside edges of the beam connectors that is generally within 1/16″ or so of what the desired bay dimension is. You do not want to measure between the furthest outside edges of the beam connectors or the measurement will be too long.

Deck Width Chart:

  • 96″ beams require Two (2) 46″ wide wire decks
  • 108″ beams require Two (2) 52″ wide wire decks
  • 120″ beams require Two(2) 58″ wide wire decks
  • 144″ beams require Three (3) 46″ wide wire decks

Next you want to determine the upright depth of the rack system that the decks are being used in. Example: 42″ deep upright would require a wire mesh deck that is 42″ Deep. If you are ordering wire decks to go with your existing pallet rack uprights, then you will need confirm that the measurement between the steps of your existing pallet rack beams will accommodate a channel lengths of the new decks.

For 36″ deep wire decks:

Common channel lengths are between 32-1/4″ and 32-3/8″

For 42″ deep wire decks:

Common channel lengths are between 38-1/4″ and 38-3/8″

For 48″ deep wire decks:

Common channel lengths are between 44-1/4″ and 44-3/8″

Stay connected with Big Joe

Contact Us

Thank You for visiting! Drop us a note and we will get back to you shortly